Last week a company that distributes wood veneer contacted me about digital printing on their product.
Yesterday I received a couple of 17″ wide pieces ready to fit my 4800 for printing. Of course UPS came just as I was leaving to go to the airport for Winter Play. All I had time for was to check out the product and then put it away. Since I haven’t coated and tested it, these photographs will serve to show you the 2 longer pieces I will be printing when I get back to my studio next week.
Some of the smaller pieces from their sample pack seem like they will be a little too thick, but there are many that will be just fine. Some of the pieces have an adhesive backing so they look interesting. Once I see how this works, I will post the information here and also give you information where to purchase the product.
I did finish my can piece based on the Mariposa Grove in Yosemite National Park. Thought the pics were on the hard drive I carry with me when I travel, but I guess I forgot to move them from my main computer, so next week I will show you how that piece turned out.